ATV250 19 (luci, strumentaz, clacson) .pdf

19. BULBS REMOVAL/INSTRUMENT/HORN

Mongoose/KXR 250

19
__________________________________________________________________________________

__________________________________________________________________________________

__________________________________________________________________________________

__________________________________________________________________________________

__________________________________________________________________________________

BULBS REMOVAL/INSTRUMENT/HORN
__________________________________________________________________________________

BULBS REMOVAL ----------------------------------------------------- 19- 1
INSTRUMENT (ON ROAD ONLY) ---------------------------------- 19- 4
HORN (ON ROAD ONLY)--------------------------------------------- 19- 4

19

19-0

19. BULBS REMOVAL/INSTRUMENT/HORN
BULBS REMOVAL

Mongoose/KXR 250

Headlight Wire Coupler

HEADLIGHT
Remove the front fender. (See page 2-5)
Disconnect the headlight wire coupler.
Remove the rubber boot from the bulb
socket.
Relax the lock clip to remove the bulb and
replace with a new one.

Rubber Boot

Lock Clip

Install the bulb, aligning the bulb socket
groove with the bulb tab and set the lock
clip.
Install the rubber boot.
Install the front fender in the reverse order
of removal.

TAIL/BRAKE LIGHT
Remove the bulb socket by turning it
counterclockwise.
Remove the bulb.

Bulb

Bulb Socket

Install the bulb in the reverse order of
removal.

Bulb

19-1

19. BULBS REMOVAL/INSTRUMENT/HORN
INDICATOR LIGHT
Remove the handlebar cover. (See page 2-4)
Remove the bulb sockets by pulling them
out.

Mongoose/KXR 250

Bulb Socket

Bulb

Remove the bulb.
Install the bulb in the reverse order of
removal.

Bulb Socket

Bulb

POSITION LIGHT (ON ROAD ONLY)
Remove the handlebar cover. (See page 2-4)
Remove the bulb socket by pulling it out.
Remove the bulb.
Install the bulb in the reverse order of
removal.

Bulb Socket

FRONT TURN SIGNAL LIGHT (ON
ROAD ONLY)
Remove the turn signal light lens by a
standard screwdriver.
Pull the bulb socket out from the signal light
case and remove bulb.

Turn Signal Light Lens

Bulb

Install the bulb, aligning the bulb socket
groove with the bulb tab.

19-2

19. BULBS REMOVAL/INSTRUMENT/HORN

Mongoose/KXR 250

Install the bulb socket, aligning the bulb
socket groove with the turn signal case tab.
Install the turn signal lens, aligning the turn
signal lens groove with the turn signal case
tab.

REAR TURN SIGNAL LIGHT (ON
ROAD ONLY)
Remove the screw and remove the turn
signal light lens.
Pull the bulb socket outside from the signal
light case and remove bulb.

Screw

Bule

Bulb Socket

Install the bulb, aligning the bulb socket
groove with the bulb tab.
Install the bulb in the reverse order of
removal.

19-3

19. BULBS REMOVAL/INSTRUMENT/HORN

Mongoose/KXR 250
Instrument

INSTRUMENT (ON ROAD)
REMOVAL
Remove the handlebar cover. (See page 2-4)
Disconnect the meter wire coupler and
speedometer cable.
Remove the two nuts and then remove the
instrument.

Meter Wire

Pull the bulb socket out and then remove the
instrument bulb.

Speedometer Cable

Bulb Socket

Nuts
Bulb

Install the instrument in the reverse order of
removal.

Horn Wire Leads

HORN (ON ROAD)
REMOVAL
Disconnect the horn wire leads.
Remove the bolt and remove horn.
INSTALLATION
The installation sequence is the reverse of
removal.
Bolt

Horn

19-4