checlist f18c .pdf


À propos / Télécharger Aperçu
Nom original: checlist_f18c.pdf

Ce document au format PDF 1.4 a été généré par Writer / LibreOffice 5.1, et a été envoyé sur fichier-pdf.fr le 06/10/2017 à 09:42, depuis l'adresse IP 90.48.x.x. La présente page de téléchargement du fichier a été vue 570 fois.
Taille du document: 1.5 Mo (13 pages).
Confidentialité: fichier public


Aperçu du document


Falcon BMS-F/A-18C-REV3

CHECKLISTS
FOR

NAVY MODEL

F/A-18C
FOR FALCON BMS

Falcon BMS-F/A-18C-REV3

TABLE OF CONTENT
1
2
3
4
5

NORMAL PROCEDURES
CARRIER BASED PROCEDURES
SPECIAL PROCEDURES
EMERGENCY PROCEDURES
PERFORMANCE DATA

Falcon BMS-F/A-18C-REV3

1 NORMAL PROCEDURES
1.0
1.1
1.2
1.3
1.4
1.5
1.6

PRESENTATION COCKPIT
INTERIOR CHECKS
BEFORE ENGINES START
ENGINES START
AFTER ENGINES START
BEFORE TAXI
TAXI

1 : NORMAL PROCEDURES

Falcon BMS-F/A-18C-REV3

1.0 : PRESENTATION COCKPIT
1. Lock shoot lights
2. HUD
3. AOA indexer lights
4. Left engine fire/warning light
5. Master caution light
6. Left warning/caution advisory lights
7. HUD vidéo bit panel
8. Right warning/caution advisory
lights
9. APU fire warning light
10.Right engine fire/warning light
11. Canopy internal jettisson handdle
12.Master arm panel
13.Left digital display indicator ( DDI )
14.Upfront control display ( UFC )
DED et ICP dans BMS
15.Right digital display indicator
( DDI )
16.Map gain/spin recovery panel
HMCS et CAT I-III dans BMS
17.Emergency jettison button
18.HUD control panel
19.Standby attitude reference indicator
20.Station jettison select Non actif dans
Falcon BMS
21.Landing gear and flaps position lights
22. Integrated fuel/engine indicator ( IFEI )
23.HUD video recorder panel + DED affiché sur HUD dans BMS
24.Multipurpose color display ( MPCD ) HSI + CMDS + PA dans BMS
25.Standby airspeed indicator
26.Standby altimeter
27.Standby rate of climb
indicator
28.RWR
29.RWR control indicator
Gestion RWR et EWS dans
BMS
30.Dispencer/emc panel Gestion
EWS et ECM dans BMS
31.Clock
32.Cockpit altimeter

Falcon BMS-F/A-18C-REV3

33.Select jettison button + Flaps et Landing light dans BMS
34.Landing gear handle and warning tone silence button
35.Brake accumulator pressure gage
36.Emergency and parking brake handle
37.Radar altimeter
38.Hyd 1 and Hyd pressure indicator
39.Arresting hook handle and light
40.Aircraft bureau number
41.Wing fold switch
42.Flight computer cool switch
43.Caution lights panel

44.Electrical control panel Main Power and

Falcon BMS-F/A-18C-REV3
HDPT dans BMS
45.Environement control system panel Probe
Heat and Air source dans BMS
46. Interior lights panel Instrument and interior
lights dans BMS
47.AMAC control
48.Sensor panel FCR et INS et LASER dans
BMS
49.Night vision goggle storage
50.Map and data case
51.Defrog panel + up case canopy switch
Canopy dans BMS
52.Fire test panel MAL&IND dans BMS
53.Ground power panel SMS et FCC et Master fuel et
ALT switch dans BMS
54.Exterior lights panel Formation lights et Wings
lights et Anti col Master lights dans BMS
55.Fuel panel Fuel dump et fuel trans et Fuel door
dans BMS
56.Auxiliaire power unit EPU et JFS start dans BMS
57.Flight control system panel Trim yaw et Eng cont
et FLCS power dans BMS
58.Communication panel 1 Missile volume et
intercom volume dans BMS
59.Antenna select panel
60.Communication panel 2 UHF fonction et UHF
mode et UFC et Channel backup dans
BMS
61.Mission computer and hydraulic isolate panel
62.Obogs

Falcon BMS-F/A-18C-REV3

1.1 : INTERIOR CHECKS
[ ] Number of the PANELS or INSTRUMENTS
Left console and auxiliairie
1. [11] Manual Canopy Handdle – STOWED
2. [62] Oxygen supply – OFF
3. [60] COMM panel
• GXMIT on COMM2
• UFC on MAN
• Volume TCN-RWR-WPN – AS DESIRED
4. [55] PROBE switch - RETRACT
5. [55] DUMP switch - OFF
6. [54] INTR WING switch - NORM
7. [ ] Throttles - OFF
8. [36] PARK BRK handle – SET
9. [33] LDG/TAXI LIGHT switch - OFF
10. [33] FLAP switch - FULL
11. [34] LDG GEAR handle – DOWN
12. [54] Radar altimeter - OFF

Front panel
1.
2.
3.
4.
5.
6.
7.
8.

[12] MASTER ARM switch - SAFE
[10] FIRE and APU warning lights - NOT PRESSED IN
[12] L(R) DDI, HI/MPCD, and HUD knobs - OFF
[18] Altitude source - SELECT
[14] COMM 1 and 2 knobs – OFF
[30] ECM mode – OFF
[29] Dispenser CHAFF and FLARE – OFF
[31] Clock - CHECK AND SET

Falcon BMS-F/A-18C-REV3

9. [19] Standby attitude reference indicator - CAGE/LOCK
10. [16] SPIN switch - GUARD DOWN/OFF

Right Console and auxiliairie
1.
2.
3.
4.
5.
6.

[39] HOOK handle - UP
[41] WING FOLD handle - SAME AS WING POSITION
[44] BATT switch – OFF
[45] BLEED AIR knob - OFF
[46] INTR LT panel - AS DESIRED
[48] Sensors - OFF

Engine Start. With a battery start, power is available to operate the
APU and engine fire warning systems, the intercom system between
the pilot and the ground, the cockpit utility light and EMI/IFEI.
For external air start, ensure that bleed air knob is OFF to avoid ATS
damage.

When the engine crank switch is on, the air turbine starter control
valve (ATSCV) opens and the air turbine starter (ATS) rotates the
engine thru the AMAD. Engine rotation is apparent almost
immediately and can be seen on the tachometer. During operation
below flight idle, the nozzles may go closed or oscillate. After the
engine lights-off and accelerates to approximately 60% rpm, the
engine crank switch returns to OFF. After both generators are on the
line, the APU runs for 1 minute, and then shuts down.

Falcon BMS-F/A-18C-REV3

To prevent engine damage during start, if an engine was not idled
for 5 minutes prior to shutdown and a restart must be made
between 15 minutes and 4 hours after shutdown, the engine must
be motored for 1 minute at 24% N2.

1.2 BEFORE ENGINES START
1. [44] BATT switch – ORIDE
• E BATT voltage - CHECK
After battery switch in ORIDE for minimum of 5
seconds, check for minimum voltage of 23.5 volts.
2. [52] FIRE switch – TEST
• Hold until all lights and aural warnings indicate test
has beensuccessfully passed
3. [51] CANOPY – UP CASE CLOSE
PROCEDURE of Squadron
• [60] Set CANAL Backup UHF set as Briefing
• [60] G XMIT – COMM1
• [14] Vol COMM1 – ON AS DESIRED
• [14] Vol COMM2 – ON AS DESIRED
• [ ] RADIO COMMS PROCEDURE

4. [56] APU – START ENG CRANK on L



READY light within 30 seconds If fire or overheat
condition is detected, the APU shuts down.
Check 25 % RPM 136° TEMP

Falcon BMS-F/A-18C-REV3

1.3 ENGINES START
1.
2.
3.
4.
5.

[22] EGINE FEED – NORM Press MODE
[45] BLEED AIR knob – L OFF
[ ] THROTTLE Advance to IDDLE and PRESS DETENT
[ ] ENG CRANK switch confirm OFF at 60 % RPM
[ ] Check all ALARM LIGHTS OFF, only SEAT ON

Ground idle
N2
EGT
Fuel flow
Nozzle
Oil pressure (warm oil)

F404-GE-400
61 to 72%
190° to 590°C
420 to 700 pph
73 to 84%
45 to 110 psi

F404-GE-402
63 to 70%
190° to 590°C
420 to 900 pph
73 to 84%
45 to 110 psi

1.4 AFTER ENGINES START
1.
2.
3.
4.
5.
6.
7.
8.
9.

[21] GEAR Lights – ON 3 whites
[13] DDI / MPCD – ON Digital Display Indicator
[16] HUD - ON Head Up Display
[14] DED - ON Display Entry Data
[53] FCC / MMC – 4 A ON Fire Control Computer / Modular
Mission Controler
[53] SMS – 2 A ON Store Management System
[53] GPS – 3 A ON Ground Positionning System
[14] DL – Press DL Data Link
[48] INS – GROUND Initial Navigation System 8 minutes for
alignement

Falcon BMS-F/A-18C-REV3

10. [48] RADAR FCR – OPR Fire Control Radar
Check on Right DDI FCR TEST running
11. [53] RDR ALT – EXT PWR sur NORM Radar ALT Standby
12. [44] HDPT L/R – LGEN / RGEN sur ON
13. [60] CNI – sur UFC Communication Navigation IFF
14. [15] DTC – On DDI press OSB highlighted and OSB DTE
and OSB LOAD
15. [15] MFL – On DDI press OSB highlighted and OSB TEST and
OSB CLEAR
16. [06] IF STORES LIGHT is ON CHECK CAT1/3 on Button IR COOL
on panel 16
17. [ ] RADIO COMMS PROCEDURE
18. [ ] SPEED BRAKES – TEST CYCLE on brakes in Throttle
bouton
19. [ ] RUDDER PEDAL – CYCLE 30° Left and right
20. [41] WINGFOLD – SPREAD
21. [33] FLAP switch – AUTO
22. [ ] CONTROL STICK – CYCLE Left, right, up, down
23. [ ] APU – VERIFY OFF
24. [22] FUEL quantity – Press QTY and CHECK all and SET
BINGO
25. [25] ALTIMETER – SET QFE with Knob
26. [25] STORES page – ON DDI Verify proper store inventory and
station status
27. [48] INS – NAV Initial Navigation System after 8 minutes for
perfect alignement or RDY flash after 4 minutes for minimum
alignement on page INS.
28. [29] RWR – Press POWER Radar Warning Receiver
29. [30] EWS-RWR – ECM on XMIT
30. [30] EWS-JAMMER – Dispenser on BYPASS Jammer
31. [29] CHAFF – Click on ANALR DMR

Falcon BMS-F/A-18C-REV3

32. [29] FLARE – Click on DIS TYPE
33. [24] MODE – MPCD OSB 19 As desired
34. [24] PGRM – MPCD OSB 20 As desired
35. [30] ECM – AUX REL on NORMAL Set as required
36. [29] HANDOFF – Short press ENABLE OFFSET Diamond float
mode
37. [58] AUDIO – SET volume all and CHECK
38. [14] DED-UFC – CHECK Bingo, MSL, ALOW, TACAN, IDM
39. [55] PROBE EXTEND – TEST
40. [ ] RADIO COMMS PROCEDURE INS READY TAXI

1.5 BEFORE TAXI
1. [15] WAYPOINT – CHECK Flight plan on HSD
2. [01] NWS – ON
3. [ ] CHOCKS – Contact tower and REMOVE CHOCKS

1.5 TAXI
1.
2.
3.
4.
5.

[ ] RADIO COMMS PROCEDURE
[ ] SEAT – ARM
[ ] WHEEL BRAKES - CHECK
[ ] NOSEWHEEL STEARING – CHECK
[53] RDR ALT – EXT PWR sur RESET Radar ALT ON

When using brakes, apply firm, steady brake pedal pressures. Use
nosewheel steering whenever possible, minimizing differential
braking. Avoid dragging brakes or light brake applications

Falcon BMS-F/A-18C-REV3

except as necessary for drying wet brakes. Wet brakes can have as
much as 50% reduced braking capacity. Hard momentary braking
with wet brakes during taxi can reduce drying time.
Taxi. As aircraft starts to roll, apply brakes to check operation. When
clear, check nosewheel steering in both directions in the high mode
to ensure proper operation. At high gross weight, make all turns at
minimum practicable speed and maximum practicable radius.


Aperçu du document checlist_f18c.pdf - page 1/13

 
checlist_f18c.pdf - page 2/13
checlist_f18c.pdf - page 3/13
checlist_f18c.pdf - page 4/13
checlist_f18c.pdf - page 5/13
checlist_f18c.pdf - page 6/13
 




Télécharger le fichier (PDF)




Sur le même sujet..





Ce fichier a été mis en ligne par un utilisateur du site. Identifiant unique du document: 00547865.
⚠️  Signaler un contenu illicite
Pour plus d'informations sur notre politique de lutte contre la diffusion illicite de contenus protégés par droit d'auteur, consultez notre page dédiée.