Yaw Gyro pour pilote auto Autohelm Raymarine English.pdf


Aperçu du fichier PDF yaw-gyro-pour-pilote-auto-autohelm-raymarine-english.pdf - page 3/7

Page 1 2 3 4 5 6 7



Aperçu texte


Working in the AST mode the Course Computer is able to automatically and
continuously adjust its various parameters according to the state of the sea and the
behavior of the ship.
• Type 100/300 Course Computers : when the “Yaw Gyro” is connected to the
Course Computer, the anti-yaw mode is activated by selecting the response
sensitivity to level 3.
“Yaw Gyro” is not taken into account on levels 1 and 2 which are used by flat or
calm sea.
4 - Installation
The installation is easy, just connect the two wires data-yellow and screen (ground /
zero Volt) of the "Yaw Gyro" to the "Rate Gyro" pins of the terminal block of the
Course Computer and the red wire to a +12 Volts source :
Type 100/300
- The ground wire screen/zero-volt must be connected to the gray pin of the "Rate
Gyro 1" terminal block of the Course Computer.
- The red power supply wire (+ 12volts) can be connected to the red pin of the same
"Rate Gyro1" terminal block or to any other +12 Volts power supply for instruments.
- The yellow wire which is the rate of turn information provided by the “Yaw Gyro” to
the Course Computer must be connected to the yellow pin of the "Rate Gyro1"
terminal block .